EPEC NAMELIST¶

Short Description¶

Description of EPEC namelist

namelist

TSTART: Simulation start time (ms)
TEND: Simulation end time (ms)
PSTART: Start time for PHASE/EPEC plots (ignored if negative) (ms)
PEND: End time for PHASE/EPEC plots (ignored if negative) (ms)
MPOL: PHASE/EPEC plots only show data for mode with poloidal mode number MPOL (ignored if negative)
DTR: Time interval between successive RESCALE calculations (ms)
DTF: Time interval between successive fFile/nFile calculations (ms)
DTP: Time interval between successive PHASE runs (ms)
RESTART: Flag for restarting each PHASE run, rather than using previous run as initial condition
ANSTART: Initial AN for RESCALE n_e scan
ANEND: Final AN for RESCALE n_e scan
ATSTART: Initial AT for RESCALE T_e scan
ATEND: Final AT for RESCALE T_e scan
ARSTART: Initial AR for RESCALE R_0 scan
AREND: Final AR for RESCALE R_0 scan
ACSTART: Initial AC for RESCALE CHI_PHI scan
ACEND: Final AC for RESCALE CHI_PHI scan
APSTART: Initial AP for RESCALE P scan
APEND: Final AP for RESCALE P scan
AWSTART: Initial AW for RESCALE w_E scan
AWEND: Final AW for RESCALE w_E scan
QSTART: Initial Q95 for RESCALE q_95 scan
QEND: Final Q95 for RESCALE q_95 scan